Download and install the most recent ATEM Switcher software from Blackmagic Design’s Support page.
Each “update” is a full program installation, so the most recent version will suffice to bring your software and firmware up to date.
Set a Static IP Address
Connect your computer to the ATEM via USB.
When connected via USB (as opposed to ethernet), you will be able to change the IP address of the ATEM within the “ATEM Setup” application.
It is recommended to set a static IP address for your ATEM. Make sure the address is is appropriate to your router’s subnet range.
Your settings will likely differ, but for example, the first three numbers all match here:
Router 192.168.1.1
Computer 192.168.1.123
ATEM 192.168.1.201
Within Companion, make sure the ATEM Module’s Target IP has been updated with the new IP Address that was set for the ATEM hardware (as previously mentioned in the Companion setup).
Troubleshooting
Companion speaks directly to the ATEM via the Ethernet Network and does not require the ATEM Software Control to be running in order to operate.
Note that Companion only speaks to the ATEM via Ethernet, not the USB port. While you can setup the ATEM’s static IP address via a USB connection, you will need an Ethernet connection to control the ATEM via Companion.
Note that as of DJF 4.1+ the ATEM Software Control Macros file is no longer required to be installed. All operations are now handled internally within Companion.